Honda Accord Distributor O Ring Replacement

1. Disconnect the negative cable from the battery;
2. Mark the location of each wire, then take ignition wires off the distributor cap. Accord engine fire order is 1,3,4,2.


3. Rotate engine from this hole by using 19mm socket.



4. Get the piston in the No. 1 cylinder to the Top Dead Center (TDC) spot. 



5. Make sure rotor is pointing to No. 1 cylinder cable position.



6. Make the marks between distributor housing and engine block. 





7. Carefully take distributor out from the engine. O ring seems leaking long time.





10. Clean the parts and install the new o ring to the distributor and the install the distributor to the engine. Make sure the marks are alignment up.

11. Connect all wires and cables and you are done !